[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: your mail


I am going to place an allow for "chisel" on:


This is a machine under our control and a full NOAAPORT ingest system.

This will allow you all feeds...CONDUIT is a special situation as is
CRAFT, and of course NLDN, GEM and NOGAPS output.

I will correct info re iita..

Jeff Weber                                    address@hidden        :
Unidata Program Center                        PH:303-497-8676        :
University Corp for Atmospheric Research      3300 Mitchell Ln       :
http://www.unidata.ucar.edu/staff/jweber      Boulder,Co 80307-3000  :

On Mon, 14 Jul 2003, Unidata Support wrote:

> ------- Forwarded Message
> >To: address@hidden
> >cc: address@hidden
> >From: Celia Chen <address@hidden>
> >Subject: failover
> >Organization: UCAR/Unidata
> >Keywords: 200307092001.h69K1uLd009344
> Hi,
> RAP was allowed to have only one of our LDM servers setup to get feed
> from thelma few weeks ago.  It is important for us to make sure that we
> get continuous realtime LDM data feed for many of our projects.  I
> would like to know what is the best way to go about it.  Please
> advise.
> Also, as I was looking for information on a failover sheme and how to
> setup.  I found that "iita" is still listed as a UCAR failover
> machine.  We now use "chisel" as the machine that gets feed from
> thelma.  "iita" is not a UCAR wide machine anymore and it is configure
> to only receive the WSI data from  wsihcsn.unidata.ucar.edu and rest of
> the data feed comes from chisel. Is there a default failover machine at
> Thanks in advance.
> Celia
> ------- End of Forwarded Message