[idvusers] assign vertical coordinate (value) to flat ADDE image

• To: "idvusers@xxxxxxxxxxxxxxxx" <idvusers@xxxxxxxxxxxxxxxx>
• Subject: [idvusers] assign vertical coordinate (value) to flat ADDE image
• From: Valentijn Venus <venus@xxxxxx>
• Date: Wed, 16 Feb 2011 00:44:48 +0100

IDVers,

I have a flat ADDE image in IDV which plots in the Map Display on 0 msl. But in 
reality the data represents a pressure level (I.e. 800 mb).

I was hoping I could use jython to define a vertical coordinate axis, and then 
augment my (meta)data so the image plots nicely at the corresponding height in 
the atmosphere…

Ideas? Any pointers to which methods from the VisAD/IDV APIs I should start 
with….

Cheers, Tyn

________________________________
Faculty of Geo-Information Science and Earth Observation (ITC)
University of Twente
Chamber of Commerce: 501305360000

E-mail disclaimer
The information in this e-mail, including any attachments, is intended for the 
addressee only. If you are not the intended recipient, you are hereby notified 
that any disclosure, copying, distribution or action in relation to the content 
of this information is strictly prohibited. If you have received this e-mail by 
mistake, please delete the message and any attachment and inform the sender by 
return e-mail. ITC accepts no liability for any error or omission in the 
message content or for damage of any kind that may arise as a result of e-mail 
transmission.

• Follow-Ups:
  • Re: [idvusers] assign vertical coordinate (value) to flat ADDE image
    • From: Don Murray