Due to the current gap in continued funding from the U.S. National Science Foundation (NSF), the NSF Unidata Program Center has temporarily paused most operations. See NSF Unidata Pause in Most Operations for details.

Re: loading point-data to idv

Two hours later, reading a lot of the IDV and NetCDF source, I managed to get my file working: I didn't manage to find anywhere the polar_stereographic parameter "straight_vertical_longitude_from_pole" which is defined in CF-1.0 Appendix F.
Using instead "longitude_of_projection_origin" (not mentioned in CF-1.0, but in GDV convention and the source), the file below worked fine. I used the same value for both parameters: Did I misunderstand the "straigth_vertical_longitude_from_pole", or there it simply a bug concerning polar_stereographic in the netcdf CF-1.0 implementation? 

Best regards,

Heiko

Heiko Klein wrote:
After reading the projection paragraph 5.6 of CF-1.0 again, I understood your comment about the NATTOT_year_cf.nc. Adding the coordinates = "lon lat" flag to the variables made variables longitude and latitude disappear in the IDV variable listing. But it still doesn't show any longitude values when showing a variable: The latitude values are all correct, but for longitude, I allways get 'NA'. 

I uploaded the corrected file again:
ftp://emepftp@xxxxxxxxxx/heikok/NATTOT_year_cf.nc
I hope somebody has time to give me a hint where my file is wrong.

Best regards,

Heiko

Heiko Klein wrote:
  • 2005 messages navigation, sorted by:
    1. Thread
    2. Subject
    3. Author
    4. Date
    5. ↑ Table Of Contents
  • Search the idvusers archives: