Re: Some code to share - VisADJython strikes back!

• To: Chi-chi Ekweozor <cce100@xxxxxxxxxx>
• Subject: Re: Some code to share - VisADJython strikes back!
• From: Curtis Rueden <curtis@xxxxxxxxxxxxx>
• Date: Fri, 23 May 2003 10:41:13 -0500

Hi Chi-chi,

>C:\VisADJython>jythonc --core --jar sim3daudio sim3daudio.py
>Bad command or file name

Looks like it's time to hack into the batch file to figure out
what's going wrong.  Open up jythonc.bat in a text editor.

Step 1: remove the "@echo off" line that is probably at the
beginning of the file.  If there is no such line, perhaps there
are lines that start with "@"?  Both of those syntaxes mask
echoing of the actual commands getting run.  In this case, it
is important to determine which command is the "Bad" one.

After resaving the batch file, run the command again and see
which command is going bad.  Then figure out why.

Without additional knowledge, that's all the advice I can offer.

-Curtis

• References:
  • Some code to share
    • From: Chi-chi Ekweozor
  • Re: Some code to share - VisADJython strikes back!
    • From: Chi-chi Ekweozor
  • Re: Some code to share - VisADJython strikes back!
    • From: Chi-chi Ekweozor