first check your registry.xml (in the same dir as your pqact ( s ) )
under <pqact>
you should see something like:
<pqact>
<config-path>/home/ldm/etc/pqact.conf</config-path>
<datadir-path>/home/ldm/data</datadir-path>
</pqact>
You may be actually writing the nexrad data, but it will be in a subdirectory
of above.. such as you may actually have files writing in:
/home/ldm/data/data/gempaknwxrad/NIDS../…/
Etc..
The second most common mistake is checking that you have tabs instead of spaces
in your entry:
NEXRAD3 <tab> ^SDUS….
<tab>FILE
These are the most common mistakes.. good luck :)
Cheers,
--patrick
-------------------------------------------------------
Patrick L. Francis
Vice President of Research & Development
Aeris Weather
http://aerisweather.com/
http://modelweather.com/
http://facebook.com/wxprofessor/
--------------------------------------------------------
From: ldm-users-bounces@xxxxxxxxxxxxxxxx
[mailto:ldm-users-bounces@xxxxxxxxxxxxxxxx] On Behalf Of Keith Latteri
Sent: Sunday, September 13, 2015 2:04 PM
To: LDM <ldm-users@xxxxxxxxxxxxxxxx>
Subject: [ldm-users] LDM pqact issue.
Hello,
I am currently trying to add data to /data/gempak/ using the NEXRAD3 feed.
However, I am running the following:
NEXRAD3 ^SDUS[23578]. .... ([0-3][0-9])([0-2][0-9])([0-6][0-9]).*/p(...)(...)
FILE -overwrite -close
/data/gempak/nexrad/NIDS/\5/\4/\4_(\1:yyyy)(\1:mm)\1_\2\3
But it isn't adding data to the directory, this isn't a permissions issue. I
wanna note, I am using this LDM server also for AWIPS2. I don't know if
AWIPS/EDEX is conflicting or not.
--
Regards,
Keith Latteri
The Hurricane Network
