Re: [ldm-users] Feed Data Question

Thanks Daryl,

My issue was much more basic.  After adding my feed data to ldmd.conf, I did 
not restart the LDM service.  Now I am getting the feed info.

Thanks again guys.  

Mack

----- Original Message -----
From: "daryl herzmann" <akrherz@xxxxxxxxxxx>
To: "Mack Jenkins" <mack.jenkins@xxxxxxxxxxxxxx>
Cc: ldm-users@xxxxxxxxxxxxxxxx
Sent: Friday, September 24, 2010 10:14:25 AM GMT -05:00 US/Canada Eastern
Subject: Re: [ldm-users] Feed Data Question

On Fri, 24 Sep 2010, Jenkins, Mack wrote:

> So, I have LDM and GEMPAK installed, and followed the instructions I 
> found on the website.  I have also gotten access to the data feeds that 
> are needed for my setup.  The issue I am having is that when I run 
> "ldmadmin watch" I do not see any info.  It is working on an older 
> system that was set up a while ago by someone else, so I know what the 
> output should look like.
>
> Just wondering if anyone can give me a suggestion and point me in the 
> right direction?

A couple of ideas:

  1) Check that you have data request entries in your ldmd.conf file.

  2) Check the ldm log files to see if any errors about not being able
     to connect or some other errors appear.

  3) Are you running the latest version of LDM and is your system clock
     correct?

  4) You can use the notifyme command to see if your upstream host is
     getting data.  You can use the same pattern you used in the ldmd.conf
     file.  For example:

      notifyme -v -l - -p ".*" -f WMO -h idd.unidata.ucar.edu

Good luck,
   daryl

-- 
Mack J. Jenkins, II
mack.jenkins@xxxxxxxxxxxxxx
System Support Specialist II
Earth & Atmospheric Sciences



  • 2010 messages navigation, sorted by:
    1. Thread
    2. Subject
    3. Author
    4. Date
    5. ↑ Table Of Contents
  • Search the ldm-users archives: