[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: It worked!

Steve:

I could swear (**&^%$$) that I did exactly that - several times -
yesterday with no results. Today, I try it and it works. Thank you.

I have another question. When I plot up temp and mixing ratio, it
contours with values TMPC*10 and SMXR*10, even though I don't remember
ever setting those parameters to ten times the observed value. Any
ideas on what I could be doing wrong?

I have two grid files created. THe first is the one that dumped me out
at the 2000 time period (if you recall that conversation yesterday). I
can plot earlier hourlies from this file. The second is just a single
dattim and a single parameter, TMPC.  The single gridded files gives me
TMPC in the usual degrees C as expected. The other files with eight
paramters and times from 0000-1900 gives me the TMPC*10 and SMXR*10
plotted data. I don't understand why the difference.

Thanks
Rich

>To: NECOPS research account <address@hidden>
>cc: address@hidden
>Subject: 1999311: HELP! 
>Date: Thu, 11 Mar 1999 19:05:25 -0700
>From: Unidata Support <address@hidden>
>
>
>Rich,
>if you gridded TMPC from surface data, then to contour
>the grid, you will use:
>GVCORD = NONE
>GLEVEL = 0
>GFUNC = TMPC
>
>Can you show me the output from gdinfo? And what you are 
>using for gdcntr parameters?
>
>Steve Chiswell
>
>>From: NECOPS research account <address@hidden>
>>Organization: .
>>Keywords: 199903112115.OAA25778
>
>>Chiz:
>>
>>Okay, i went back and created a new grid file using gdcfil; then went into 
>>oabsfc and gridded data from a surface (sao) file using only one time and one 
>>parameter (tmpc), after making sure that the data exists; then did gdinfo and 
>>saw pretty much the same output that you sent in your email. Then I went to 
>>gdcntr to plot something, and after running, but before accepting by hitting t
>> he
>><cr>, I notice that the max and min values for tmpc were 0.00 and 0.00. So I 
>>continued anyway to find that nothing was plotted.
>>
>>Also, when I do gdlist, it comes up with a "dg -23" message following by a "@"
>> ,
>>whatever that means.
>> 
>>I'm in a major crunch to get this done. Can you help me?
>>
>>Thanks. I'll be in my office for another hour or so.
>>
>>Rich
>>
>
>**************************************************************************** <
>Unidata User Support                                    UCAR Unidata Program <
>(303)497-8644                                                  P.O. Box 3000 <
>address@hidden                                   Boulder, CO 80307 <
>---------------------------------------------------------------------------- <
>Unidata WWW Service                        http://www.unidata.ucar.edu/      <
>**************************************************************************** <