Can you do
ncdump -h filename
and send the results
-Roy
On Nov 22, 2008, at 12:27 PM, Rich Gwozdz wrote:
Hello group,
I am pretty new to netcdf so forgive me if there is an obvious
answer to
this question. I have a large netcdf file: monthly temperature, state
of washington, at 1/16 degree resolution, at monthly intervals from
1900
- 2000. I would like to extract the time series of monthly temps
for a
single grid cell and write it to a text file. I've looked into using
ncdump to do this but can seem to find the right way. Suggestions?
Rich
_______________________________________________
netcdfgroup mailing list
netcdfgroup@xxxxxxxxxxxxxxxx
For list information or to unsubscribe, visit:
http://www.unidata.ucar.edu/mailing_lists/
**********************
"The contents of this message do not reflect any position of the U.S.
Government or NOAA."
**********************
Roy Mendelssohn
Supervisory Operations Research Analyst
NOAA/NMFS
Environmental Research Division
Southwest Fisheries Science Center
1352 Lighthouse Avenue
Pacific Grove, CA 93950-2097
e-mail: Roy.Mendelssohn@xxxxxxxx (Note new e-mail address)
voice: (831)-648-9029
fax: (831)-648-8440
www: http://www.pfeg.noaa.gov/
"Old age and treachery will overcome youth and skill."
"From those who have been given much, much will be expected"
