[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Another BUFR question

actually, i remember that this can't be set acturately for all the fields,
so i set it to the maximum for the fields using Pressure variable (0-7-4).
the idea was to give an estimate about the size, not the actual value.
the data size can be determine when the data is access using
bufrdata.length after the data is obtained.

float[] bufrdata = bd.getFloatData();
size = bufrdata.length;

robb...



On Wed, 9 Aug 2006, Kevin Baggett wrote:

> Robb,
> I have put the following files on ftp.ssec.wisc.edu:/pub/incoming
>
> MSG1-SEVI-MSGAMVE-0100-0100-20060715234500.000000000Z-135382.bfr
> and it's index file
> MSG1-SEVI-MSGAMVE-0100-0100-20060715234500.000000000Z-135382.bfr.bfx
> The index file says that wind speed and direction have a dimension of
> 11, but I have found it to only have a dimension of 5.
> In BufrIndexer.java, I see some code when writing out Section 3 that says:
> if( bd.getVarCount() < 5 ) {
>                ps.println( bd.getKey() +"\t"+ bd.getVarCount() +"\t"+
> bd.isNumeric() +"\t"+ bd.getName() +"\t"+ bd.getUnits() );
>                if (makeIndex) index.addParameter( bd.getKey(),
> bd.getVarCount(),
>                   bd.isNumeric(), bd.getName(), bd.getUnits() );
>             } else {
>                ps.println( bd.getKey() +"\t"+ maxLevelDim +"\t"+
> bd.isNumeric() +"\t"+ bd.getName() +"\t"+ bd.getUnits() );
>                if (makeIndex) index.addParameter( bd.getKey(),  maxLevelDim,
>                   bd.isNumeric(), bd.getName(), bd.getUnits() );
>             }
> So, for dims greater than 5, it displays the maxLevelDim??
> The file has a Pressure variable (0-7-4) and I think this is where the
> dimension is set, as that dimension is 11.
>  else {
>                    bd = (BufrData) bufrdatas.get( "0-7-4" );
>                    //ps.println( "0-7-4 ="+ bd.getName() );
>                    if( bd != null ) {
>                       dim = bd.getVarCount();
>                       maxLevelDim = dim;
>                    } else {
>                       dim = 1;
>                       maxLevelDim = 1;
>                    }
>                 }
> Anyway, not sure what this all means.
> The file above has the data for Atmospheric Motion Vectors derived from MSG.
> Thanks!
> Kevin
>

===============================================================================
Robb Kambic                                Unidata Program Center
Software Engineer III                      Univ. Corp for Atmospheric Research
address@hidden             WWW: http://www.unidata.ucar.edu/
===============================================================================