CM

Circulates the graphics color table.

Format

CM blevel elevel [keywords]

Parameters

blevel	beginning graphics color level to loop
elevel	ending graphics color level to loop

Keywords

GO=	YES	starts looping immediately
	NO	does not loop immediately (default)
INT=	interval between steps, in milliseconds; the range is 5 to 5000 (default=100)
TIMeout=	number of steps to complete before stopping (default=500)

Remarks

CM circulates the graphics colors through the specified graphics levels. Press the middle mouse button to begin, the right button to pause, and both buttons to stop the program. CM remains active until you press both mouse buttons or the program times out.

You can animate wind flow using the CM command to process the streamline output from the GRDDISP or the PTCON commands. You must use the PARAM=MOVIE keyword with these commands.

Examples

CM 1 3 INT=500

When you press the middle mouse button, the graphics will loop between color levels 1 and 3, pausing 500 msec (0.5 sec) between steps.

Time (sec)		0	0.5	1	1.5. . .
Level	1	red	blue	green	red . . .
	2	green	red	blue	green . . .
	3	blue	green	red	blue . . .

CM 2 4

This entry loops graphics color levels 2 to 4.

Contact Us • Site Map • Search • Terms and Conditions • Privacy Policy • Participation Policy

Unidata is a member of the UCAR Office of Programs, is managed by the University Corporation for Atmospheric Research, and is sponsored by the National Science Foundation.

P.O. Box 3000 • Boulder, CO 80307-3000 USA • Tel: 303-497-8643 • Fax: 303-497-8690