pqact.conf error

[Steve Emmerson]

Rout,

I suspect that the decoder "decoders/my_decoder.pl" is crashing when 
invoked in the second manner.  This hypothesis is consistent with the 
error-message from the "pqact" process.

The decoder process won't have a standard output or standard error 
streams; consequently, it must do explicit logging.  If it does, then 
look at its log messages for a clue.

Regards,
Steve Emmerson

Rout, Minaketan wrote:
> Below entry on pqact.conf gives me error:
> 
>  
> 
> This config line works fine.
> 
> IDS|DDPLUS  <TAB>    ^(..)(..)([0-9]).* (....) 
> ([0-3][0-9])([0-2][0-9])([0-9][0-9]).*/p(CFW|FWF|NOW|SFP|ZFP|MAW|NSH|OFF|GLF|SRF|ADR)(...) 
> <TAB>    PIPE  <TAB>   -close<TAB>    decoders/my_decoder.pl
> 
>  
> 
> This config line gives error message like below.
> 
> IDS|DDPLUS <TAB>     ^(..)(..)([0-9]).* (....) 
> ([0-3][0-9])([0-2][0-9])([0-9][0-9]).*/p(CFW|FWF|NOW|SFP|ZFP|MAW|NSH|OFF|GLF|SRF|ADR)(...)  
> <TAB>   PIPE <TAB>    -close <TAB>   decoders/my_decoder.pl <TAB>   \8
> 
>  
> 
>  
> 
>  
> 
> Jul 10 19:46:53 pqact[28307] ERROR: pipe_prodput: trying again:    84808 
> 20070710193046.366 IDS|DDPLUS 999  FPUS51 KBOX 101946 /pZFPBOX
> 
> Jul 10 19:46:53 pqact[28307] ERROR: pbuf_flush (793) write: Broken pipe
> 
> Jul 10 19:46:53 pqact[28307] ERROR: pipe_put: 
> -closedecoders/my_decoder.plZFP write error
> 
>  
> 
>  
> 
> The difference between two entries is; on second config line I am 
> passing argument to file.  <TAB> are properly added at proper places.
> 
>  
> 
> Any clue will be appreciated.
> 
>  
> 
> Thanks in advance.
>